How to connect to N2YN

KD2SPF

Administrator
Staff member
EchoLink access is under N2YN-R which is connected to the 800 repeater. The 750 is down for repairs. Please contact KD2SHN if there are any issues connecting.

If you’re having connection issues first try and make sure your phone EchoLink settings are setup for public proxy and you are off WiFi
 
Last edited:

KD2SPF

Administrator
Staff member
N2YN-EchoLink.jpg

Here is documentation on what and how it was done.

Information Sourced from “https://secure.echolink.org/downloads/EchoStationManual.pdf” (ATTACHED)



FT-991 like most modern Transceivers has a built-in sound card. a device like a Signalink is no longer required. Using the USB(Universal Serial Bus not Upper Side Band! ) cable you can use this cable to connect directly to the computer and use the Microphone and Speaker connection in the same manner that you would a SignaLink. THINK FT8 Connection!

Register your Callsign for "R" -> (Just donate the dollar, it's faster!)

USING DUPLEX REPEATER MODE, POST INSTALL SETTINGS BELOW:

FW port forward for 5198 & 5199 /UDP to server.

The Echolink software you have three options that must be set:

Tools > Setup

Tools > Pref

Tools > Sysop settings



SETUP:

  • Station -> Sysop
  • Station -> Login Info
  • Proxy -> None
  • Timing -> Conn 30
  • Timing -> Transmit time 300 (5mins)
  • Audio -> Input/Output=USB connections.
  • Audio -> 300hz HighPass Filter
  • Audio -> Fine tuning 6
  • Performance -> Network Buffering 13 & PC 5


PREFERENCES:

  • List -> Raise update lvl if it interferes with audio. (sweet spot for us 450)
  • Connections -> Allow Conferences to 10
  • Security -> Default settings are fine.


SYSOP:

  • RX CTRL -> VOX
  • RX CTRL -> VOX delay 400ms
  • TX CTRL -> RTS -> USB Serial connection (needed to adjust Radio settings Menu 71)
  • TX CTRL -> Key PTT
  • IDENT -> 11Min Tx
  • OPTIONS -> Keydown time 0
  • RF info -> Set GPS info
 
Last edited:
Top